Adding Incoming Telemetry “Wrappers”

The “wrappers” are human-readable and subscriber-specific names of incoming telemetry signals.

Prerequisites

• Set up Telemetry VIOs for signals from radio (1)

  1. 

• Log on to the Dispatcher App as a Console Admin.

• Select a profile that allows the Telemetry.

Process

1. In the application, click Settings, and then, from the menu, select Radios → Telemetry Settings.
   New window appears.

   

2. In the window that appears, click Add.
   New window appears.

   

3. In the window that appears, in the Description field, enter the human-readable meaning on an incoming signal.

4. From the Direction list, select Incoming.

5. Set up the signal according to the subscriber configuration:

   1. From the GPIO Pin list, select the proper Telemetry VIO number.

      Warning

      Do not specify GPIO pin number in the control. Use Telemetry VIO number instead.

      Example

      If you follow an exemplary configuration:

      • Pin “GPIO1” refers “VIO 1”; therefore, option 1 must be selected.
      • Pin “GPIO3” refers “VIO 2”; therefore, option 2 must be selected.
      • Pin “GPIO4” refers “VIO 3”; therefore, option 3 must be selected.

   2. From the Action list, select the relevant option:

      • Select Impulse to indicate a pulse detection on the Telemetry VIO.
      • Select High to indicate high voltage application to the Telemetry VIO.
      • Select Low to indicate low voltage application to the Telemetry VIO.
      • Select Toggle. to indicate voltage change (high to low or low to high) on the Telemetry VIO.
   3. Click OK to save changes.

6. In the Telemetry Settings window, click Finish to apply changes.

Postrequisites

• Repeat the process for other signals.
• Assign signals to subscriber radios
• Assign actions to talkgroups

See Also

• Telemetry Setup