Skip to content

Adding Outgoing Telemetry “Wrappers”

The “wrappers” are human-readable and subscriber-specific names of incoming telemetry signals.

Prerequisites§

Process§

  1. In the application, click Settings, and then, from the menu, select Radios → Telemetry Settings.
    New window appears.

  2. In the window that appears, click Add.
    New window appears.

  3. In the window that appears, in the Description field, enter the human-readable meaning on an incoming signal.

  4. From the Direction list, select Outgoing.

  5. Set up the signal according to the subscriber configuration:

    1. From the GPIO Pin list, select the proper Telemetry VIO number.

      Warning

      Do not specify GPIO pin number in the control. Use Telemetry VIO number instead.

      Example

      If you follow an exemplary configuration:

      • Pin “GPIO1” refers “VIO 1”; therefore, option 1 must be selected.
      • Pin “GPIO3” refers “VIO 2”; therefore, option 2 must be selected.
      • Pin “GPIO4” refers “VIO 3”; therefore, option 3 must be selected.

    2. From the Action list, select the relevant option:

      • If Telemetry VIO is configured to On Pulse Command, select Impulse.
      • If Telemetry VIO is configured to On Toggle Voltage Command, select Toggle.High
      • If Telemetry VIO is configured to On Voltage High/Low Command and you wish to apply high-voltage signal to a pin, select High.
      • If Telemetry VIO is configured to On Voltage High/Low Command and you wish to apply high-voltage signal to a pin, select Low.
    3. Click OK to save changes.

  6. In the Telemetry Settings window, click Finish to apply changes.

Postrequisites§

See Also§